11.5.3 Deleting all locking media authorisations simultaneously
Only those locking medium authorisations are deleted that were added using the same Program-
Master that is being used to delete them.
These step-by-step instructions show you how to delete all locking device authorisations while
keeping the Program-Master stored in the locking device. Alternatively, you can also delete the
Program-Master from the locking device, and this will also delete all locking device authorisations
that were added using this Program-Master.
Procedure:
Steps Signal
1. Hold the Program-Master in the reading field of the locking device for approx. 5 seconds.
The Program-Master is deleted. 2x short
green
2. Remove the Program-Master from the reading field of the locking device.
The Program-Master and all locking medium authorisations that were added with this Program-Master are now
deleted from the locking device.
Page 66 of 83 Wide shield replacement handle set ILS-I
11.5 Locking media
Overview: Use of master media
Help & troubleshooting Technical data Maintenance & disposal Operation Administration Assembly Basic information
To Next Page
Loading...
