EasyManua.ls Logo

CF 400 CL - Namestitev Plovnih Blokov; Stanje Vode V Bazenu

CF 400 CL
185 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
131
APPENDIXPIÈCES DÉTACHÉESVZDRŽEVANJE
• Namestitev filter kartuše
Ponovno namestite filter kartušo v napravo. Filter kartuša je poravnana z vhodom vode.
Vstavite jo v sesalec. Pokrijte ga s pokrovom in preverite, da se filter kartuša popolnoma
prilega.
7. After restarting, the machine will execute the corresponding cleaning
program according to the preset parameters
Note:
1. When using App, it needs to obtain Bluetooth use permission and
location permission of the mobile phone
2. App is suitable for ios14 and above, and Android 8.0 and above.
3. To obtain weather information in APP, you need to turn on Location
service.
When it is difficult for the machine climb
the wall, it cannot clean the waterline,
and it tilts seriously when climbing the
wall, solve the problems according to the
figure. If the machine climbs the wall
normally, the following operations are
not required. After removing the
adhesive, two top floating blocks are
attached to the machine. Carry out
installation according to (Figure 6-1).
Attention:
1. Before installation, ensure that there is no water in the bonding
position.
2. There is adhesive on the back of the top floating block. When installing
the top floating block to the big cover, the edges of top floating block must
be glued properly. After 24 hours, the machine can be put into the pool for
work.
12
VI. Installa�on of floa�ng blocks (op�onal)
Floating blocks
Figure 6-1
NAMESTITEV PLOVNIH BLOKOV (OPCIJSKO)
Naslednji koraki niso potrebni, če naprava
normalno pleza po steni. Če naprava težko
pleza po steni, ne čisti vode in se lahko nagne.
Tave rešite, kot prikazuje slika. Po tem, ko
odstranite lepilo, pritisnite zgornja plovna bloka
na napravo. Namestite skladno s sliko 6-1.
Pozor:
1 • Pred namestitvijo se prepričajte, da v
veznem položaju ni vode.
2 • Na hrbtni strani zgornjega plovnega bloka
se nahaja lepilo. Med namestitvijo zgornjega
plovnega bloka na veliki pokrov je treba
zgodnji plavajoči pokrov ustrezno prilepiti.
Po 24 urah lahko napravo znova potopite v
bazen in vklopite delovanje.
Slika 6-1
Plovni blok
STANJE VODE V BAZENU
Opomba: Stanje vode v bazenu mora upoštevati spodnje zahteve:
PH: 7,0-7,4
Temperatura: 10 °C-35 °C
Sol: največ 5.000 ppm
Klor: največ 2 ppm

Table of Contents

Related product manuals