Challenge EH-3D - Removing the Cutting Blocks; Removing the Drills from the Spindle

5.0 Operation
15
Figure 8
5.8 Removing the Cutting Blocks
Each cutting block is removed by inserting your fingers in the hole provided in the frame (under the
table) and pushing up on the cutting stick knock out. There are three holes: one on each side of the
frame and one in the front.
5.9 Removing the Drills from the Spindle
Remove the drift hole cover from the spindle to expose the drift hole. Then, with the flat side down,
insert the drill drift into the hole and lift upward. The upward movement forces the drill down and
releases it from the spindle.