Chamberlain WD962KPEV - Wire the Door Control to the Garage Door Opener

22
Install the Door Control
1.5 Position the bottom hole of the door
control over the screw and slide
down into place.
1.6 Lift the push bar up and mark the top hole. 1.7 Remove the door control from the wall
and drill a 5/32 inch (4 mm) hole for
the top screw.
1.8 Position the bottom hole of the
door control over the screw and
slide down into place. Attach the
top screw.
DRYWALL
6ABx1-1/2"
Drywall Anchor
6-32x1"
GANG BOX
2 Wire the door control to the garage door opener
HARDWARE
Insulated Staple
PRE-WIRED INSTALLATIONS: When wiring
the door control to the garage door opener
make sure you use the same wires that are
connected to the door control.
2.1
Run the white and red/white wire from the door control to
the garage door opener.Attach the wire to the wall and
ceiling with the staple (notapplicable for gang boxor pre-
wired installations).Do notpierce the wire with the staple
as this may cause a short or an open circuit.
Staple
2.2
Strip 7/16 inch (11 mm) ofinsulation
from the end of the wire near the
garage door opener.
7/16"
(11 mm)
2.3
Connectthe wire to the red and
white terminals on the garage
door opener. To insert or
release wires from the terminal,
push in the tab with screwdriver
tip.
RED
WHITE
WHITE
GREY