16
To preventpossible OVERHEAT NG of the end panel or lightsocket:
• Use ONLY A19 incandescent or compact fluorescent lightbulbs.
• DO NOT use incandescent bulbs larger than 100W.
• DO NOT use compact fluorescent lightbulbs larger than 26W (100W) equivalent.
• DO NOT use halogen bulbs.
• DO NOT use short neck or specialty light bulbs.
6.1 Pull on the top sides ofthe light lens and
rotate the light lens down.
6.2 Insert an A19 incandescent or compact
fluorescentlight bulb (100 watt maximum),
into the lightsocket.
6.3 Rotate the lensup to close.
NOTE: The use of short neck or speciality light
bulbs may overheat the end panel or light socket.
7 Attach the emergency release rope and handle
To preventpossible SERIOUS INJURY or DEATH from a falling garage door:
• If possible, use emergency release handle to disengage trolley ONLY when garage door is
CLOSED. Weak or broken springs or unbalanced door could result in an open door falling
rapidly and/or unexpectedly.
• NEVER use emergency release handle unless garage doorwayis clear of persons and
obstructions.
• NEVER use handle to pull door open or closed.Ifrope knotbecomesuntied,you could fall.
7.1 Insert one end of the emergency release
rope through the handle. Make sure that
“NOTICE” is right side up. Tie a knot at
least 1 inch (2.5 cm) from the end of the
emergency release rope.
7.2 Insert the other end of the emergency
release rope through the hole in the
trolley release arm. Make sure the
handle is 6 feet (1.83 m) above the floor
and secure with a knot.
NOTE: If it is necessary to cut the emergency
release rope, seal the cut end with a match or
lighter to prevent unraveling. Ensure the
emergency release rope and handle are
above the top of all vehicles to avoid
entanglement.
Installation
6 Install the light bulbs
To Next Page
Loading...
Need help?
General
