30
1 Program the
Travel
Withouta properlyinstalled safetyreversal system, persons (particularlysmall children) could be SERIOUSLY INJURED or K LLED by a closing garage door.
• Incorrectadjustmentof garage door travel limits will interfere with proper operation of safety reversal system.
• After ANY adjustments are made, the safety reversal system MUSTbe tested. Door MUSTreverse on contact with 1-1/2" (3.8 cm) high object(or 2x4 laid flat) on
floor.
1.1 Press and hold the
AdjustmentButton until
the UP Button beginsto
flash and/or a beep is
heard.
1.2 Press and hold the UP Button until the door is in
the desired UP position.
NOTE: The UPand DOWNButtons can be
used to move the door up and down as needed.
1.3 Once the door is in the desired UP position
press and release the AdjustmentButton.The
garage door opener lights will flash twice and
the DOWN Button will begin to flash.
1.4 Press and hold the DOWN Button until the door
is in the desired DOWN position.
NOTE: The UPand DOWNButtons can be
used to move the door up and down as needed.
1.5 Once the door is in the
desired DOWN position
press and release the
AdjustmentButton. The
garage door opener
lights will flash twice
and the UP Button will
begin to flash.
1.6 Press and release the UP Button. When the
door travelsto the programmed UP position,the
DOWN Button will begin to flash.
1.7 Press and release the DOWN Button.The door
will travel to the programmed DOWN position.
Programming is complete.
*
If the garage door opener lights are flashing 5
times during the steps for Program the Travel,the
programming hastimed out.If the garage door
opener lightsare flashing 10 times during the steps
for Program the Travel,the safetyreversing
sensorsare misaligned or obstructed (refer to
page 28).When the sensorsare aligned and
unobstructed, cycle the door through a complete
up and down cycle using the remote control or the
UP and DOWN buttons.Programming is complete.
If you are unable to operate the door up and down,
repeat the steps for Programming the Travel.
Adjustments
To Next Page
Loading...
Need help?
General
