Chattanooga Intelect Mobile 2 User Manual


APPENDIX
EN
|
Intelect
®
Mobile 2 ELECTROTHERAPY User Manual
ELECTROMAGNETIC COMPATIBILITY EMC TABLES CONTINUED
Guidance and Manufacturer’s Declaration - Electromagnetic Immunity
The Intelect
®
Mobile  is intended for use in the electromagnetic environment specified below.
The customer or the user of the Intelect
®
Mobile  should assure that it is used in such an environment.
Immunity Test IEC  Test Level Compliance Level Electromagnetic Environment - Guidance
Electrostatic dis- charge
(ESD)
IEC --
± kV contact
± kV air
± kV contact
± kV air
Risk assessment on the Intelect
®
Mobile  indicates the compliance levels
claimed are acceptable when ESD-precautionary measures are taken.
The Intelect
®
Mobile  may be susceptible to Electrostatic Discharge (ESD) at
greater than ± kV when first grasping either the Ultrasound or Laser applicator.
In the event of such a discharge, the Intelect
®
Mobile  may experience
communication loss with the installed modules. The Intelect
®
Mobile  will
termi- nate all active outputs (stim, ultrasound, laser), automatically place the
unit in a safe state, and issue an error message  or .
To recover from an error message  or , turn the unit o and on using the
ON/OFF switch located at the top of the
display. Once the system restarts, re-initiate all treatments that were
interrupted.
To prevent Electrostatic Discharge (ESD) at greater than ± kV:
• Grasp and hold the Ultrasound or Laser applicator prior to starting treatment.
If the applicator must be put down prior to completion of treatment, stop the
current treatment first and then place the applicator in the holder.
• Maintain humidity in the use environment to at least % relative humidity.
• Floors should be wood, concrete, or ceramic tile. If floors are covered with
synthetic material, DJO recommends implementing additional controls to
maintain relative humidity to at least %.
• Communicate these ESD-precautionary procedures to healthcare sta,
contractors, visitors and patients.
Electrical fast transient/
burst IEC --
± kV for power supply lines
± kV for input/output lines
± kV for power supply lines
± kV for input/output lines
Mains power quality should be that of a typical commercial or hospital
environment.
Surge
IEC --
+ kV dierential mode (line to line)
+ kV common mode (line to ground)
± kV dierential mode
± kV common mode
Mains power quality should be that of a typical commercial or hospital
environment.
Voltage dips, short
interruptions and voltage
variations on power
supply input lines
IEC --
<% UT (>% dip in UT) for , cycle
% UT (% dip in UT) for  cycles
% UT (% dip in UT) for  cycles
<% UT (>% dip in UT) for  sec
<% UT (>% dip in UT) for , cycle
% UT (% dip in UT) for  cycles
% UT (% dip in UT) for  cycles
<% UT (>% dip in UT) for  sec
Mains power quality should be that of a typical commercial or hospital
environment. If the user of the Intelect
®
Mobile  requires continued operation
during power mains interruptions, it is recommended that the Intelect
®
Mobile 
be powered from an uninterrupted power supply.
Power frequency (/
Hz) magnetic field
IEC --
 A/m  A/m
Power frequency magnetic fields should be at levels characteristic of a typical
location in a typical commercial or hospital environment.
NOTE: UT is the AC mains voltage prior to application of the test level.

Chattanooga Intelect Mobile 2 Specifications

General

Brand	Chattanooga
Model	Intelect Mobile 2
Category	Medical Equipment
Language	English