To prevent injury or damage:
•Do not use or charge the battery if it appears to be damaged. Signs of damage include, but
are not limited to discoloration, warping, and leaking battery fluid.
•Do not expose the battery to fire, high temperature, or direct sunlight.
•Do not immerse the battery in water.
•Do not use or store the battery inside a vehicle under hot weather condition.
•Do not drop or puncture the battery.
•Do not open the battery or short-circuit its contacts.
WARNING – Avoid contact with the rechargeable Lithium-ion battery if it appears to
be leaking. Battery fluid is corrosive and contact with it can result in personal injury and/or
property damage.
To prevent injury or damage:
•If the battery leaks, avoid with the battery fluid.
•If battery fluid gets into your eyes, immediately rinses your eyes with clean water and seek
medical attention. Please do not rub your eyes!
•If battery fluid gets onto your skin or clothing, immediately use clean water to wash off
the battery fluid.
2.4 Connecting to an Office Computer
The receiver can be connected to an office computer via a USB Type-C port for serial data
transfer. Make sure the receiver is turned on before connecting to your office computer.
The following figure shows how to connect to the computer for serial data transfer or
settings:
USB Type-C
2.5 Connecting to a Controller
2.5.1 Connecting via Bluetooth with LandStar Software
Turn on the controller → run LandStar → go to Config main menu → tap Connect.
To Next Page
Loading...
