Check Point 770 - Configuring Check Point 770;790 Appliance; Workflow

51
CHAPTER 2
Configuring Check Point
770/790 Appliance
In This Section:
Workflow ...................................................................................................................... 51
Setting up the Check Point 770/790 Appliance .................................................... 52
Connecting the Cables .............................................................................................. 52
About the PoE ............................................................................................................. 53
The appliance is a Security Gateway and uses a web application
to manage a Security Policy. After you configure the appliance
with the First Time Configuration Wizard, the default Security
Policy is enforced automatically. Use the WebUI to configure
the software blades you activated in the First Time
Configuration Wizard and fine tune the Security Policy.
Workflow
This is the recommended workflow for configuring Check Point
770/790 Appliance:
1.
Setting up the Check Point 770/790 Appliance (on page 52).
2.
Connecting the cables (on page 52).
3.
Configuring the appliance with the First Time Configuration
Wizard.
4.
Defining a security policy with the Web User Interface
(WebUI).