Check Point 770 - Configuring Anti-Spam Exceptions; Configuring Anti-Spam to Detect-Only Mode

92
Configuring Anti-Spam Exceptions
You can configure which senders, domains, or IP addresses are
not considered spam. Emails from these senders are not
inspected.
You can also identify specified senders, domains or IP
addresses for the Anti-Spam engine to automatically block.
To configure Anti-Spam exceptions:
1.
Go to Threat Prevention > Anti-Spam.
2.
Click Exceptions.
Note - Filter Spam based on: Email content must be
activated on the Anti-Spam Blade control page to apply
Anti-Spam policies.
For more information on Anti-Spam Blade control options, see
the
Check Point 600/700 Appliance Administration Guide or the
online help from the top right-hand corner of your WebUI.
Configuring Anti-Spam to
Detect-Only Mode
To configure the Anti-Spam to work in detect only mode:
1.
Click Detect-only mode.
2.
Click Apply.
Note - In detect-only mode, only logs will show. The blade
will not block emails.