Check Point 770 - Configuring the Anti-Spam Blade; Configuring the Anti-Spam Policy

90
To schedule updates:
1.
Go to Threat Prevention > Blade Control.
2.
Click Schedule Updates.
3.
Select the blades you want to update.
4.
Select the recurrence.
5.
Click Apply.
For more information on Anti-Virus Blade control options, see
the
Check Point 600/700 Appliance Administration Guide or the
online help from the top right-hand corner of your WebUI.
Configuring the Anti-Spam Blade
The Anti-Spam blade lets you block or flag emails that contain
spam. If you flag emails, you prevent the loss of any emails as
suspected spam. You can handle suspected spam differently.
You can also set to detect-only mode and use the logs to see if
there are spam attacks.
To configure the Anti-Spam blade:
1.
Go to Threat Prevention > Anti-Spam Blade Control.
2.
Select On or Off.
3.
Click Apply.
Configuring the Anti-Spam Policy
Your Check Point 770/790 Appliance is configured to manage a
typical Anti-Spam Policy. To change this policy, see Configuring
Anti-Spam Exceptions (on page 92).