Check Point 770 - Connecting to Cloud Services

102
Connecting to Cloud Services
To automatically connect to Cloud Services:
1.
In the email that the Security Gateway owner gets from the
Cloud Services Provider, click the activation link.
After you log in, a window opens and shows the activation
details sent in the email.
2.
Make sure the details are correct and click Connect.
This is a sample email:
Dear John Doe,
You are invited to activate your security services using the
Security Appliance.
Once connected, you will be fully protected by a comprehensive
security solution that will secure your assets and minimize the
risks of a data breach.
Click http://myfirewall:443476382020.
If the First Time Configuration Wizard for the Security
Appliance appears, follow the initial setup instructions in your
Getting Started Guide.
If the above activation link doesn't work, do the following:
1.
On a computer connected to the Security Appliance,
browse to the Security Appliance management interface:
http://myfirewall:4434.
2.
Go to the Home tab and select Cloud Services.
3.
Click on the Configure button.
4.
Copy your activation key
smbmgmt.provisioning.local&Sample-Gateway.domain.Pri
me&6382020 to the Activation Key field.