Check Point 770 - Page 66

66
To configure administrator access:
1.
Select the sources from where administrators are allowed
access:
• LAN - All internal physical ports.
• Trusted wireless - Wireless networks that are allowed
access to the LAN by default. This field is only shown in
wireless network modes.
• VPN - Using encrypted traffic through VPN tunnels
from a remote site or using a remote access client.
• Internet - Clear traffic from the Internet (not
recommended).
2.
Select the IP address from which the administrator can
access Check Point 770/790 Appliance:
• Any IP address
• Specified IP addresses only
• Specified IP addresses from the Internet and any IP
address from other sources - Select this option to
allow administrator access from the Internet from
specific IP addresses only and access from other
selected sources from any IP address. This option is
the default.
To specify IP addresses:
1.
Click New.
2.
In the IP Address Configuration window, select an option:
• Specific IP address - Enter the IP address or click Get
IP from my computer.
• Specific network - Enter the Network IP address and
Subnet mask.
3.
Click Apply.