Chevrolet Tracker 2025 - Flash-To-Pass; Daytime Running Lamps (DRL); Automatic Headlamp System (if Equipped); Headlamp Leveling Control

Chevrolet Tracker MY25 Owner Manual Mexico and Caribbean (GMSA-Localizing-Mexico-18450403) - 2025
70 Lighting
$
: With the headlamps on, push the turn
signal lever away from you and release, to turn
the high beams on. To return to low beams,
push the lever again or pull it toward you and
release.
This indicator light $ turns on in the
instrument cluster when the high-beam
headlamps are on.
Flash-to-Pass
To flash the high beams, pull the turn signal
lever toward you, and release.
Daytime Running Lamps (DRL)
DRL can make it easier for others to see the front
of your vehicle during the day.
The dedicated DRL will come on when all of the
following conditions are met.
For vehicles equipped with automatic
headlamp system:
•
The engine is on.
•
The light sensor determines it is daytime.
For vehicles not equipped with automatic
headlamp system:
•
The engine is on.
•
T
he exterior lamp control is in OFF.
The DRL turn off when the headlamps are
turned on or the engine is off.
Automatic Headlamp System (If
equipped)
When the exterior lamp control is set to AUTO
and it is dark enough outside, the headlamps
come on automatically.
There i
s a light sensor on top of the instrument
panel. Do not cover the sensor.
The system may also turn on the headlamps
when driving through aparking garage
or tunnel.
If the vehicle is started in adark garage,
t
he automatic headlamp system comes on
immediately. If it is light outside when the
vehicle leaves the garage, there is aslight
delay before the automatic headlamp system
changes to the Daytime Running Lamps (DRL).
When it is bright enough outside, the
headlamps will turn off or may change to DRL.
The automatic headlamp system turns off
when the exterior lamp control is turned to O
or the ignition is off.
Headlamp Leveling Control
This lets the headlamp level be adjusted to
suit the vehicle load. Correct adjustment of
the headlamp level can reduce the glare for
other drivers.
Turn the control to the position below
according to the vehicle loading condition:
•
0 =Front seat occupied.
•
1 =All seats occupied.
•
2 =All seats occupied and load in the
luggage compartment.
•
3 =Driver seat occupied and load in the
luggage compartment.