Chevrolet Tracker 2025 - Page 86

Chevrolet Tracker MY25 Owner Manual Mexico and Caribbean (GMSA-Localizing-Mexico-18450403) - 2025
Infotainment System 85
Pairing aPhone
1
. Make sure Bluetooth has been enabled on
the cell phone before the pairing process
is started.
2. Touch the Phone icon on the Home Page or
the phone icon on the shortcut tray near the
bottom of the display.
3. Touch Phones at the top of the infotainment
display. There is also aConnect Phones
option in the middle of the Phone display
which will shortcut to the Phone List menu.
4. Touch Connect Phone.
5. Select the vehicle name shown on your cell
phone’s Bluetooth Settings list.
6. Follow the instructions on the cell phone to
confirm the six-digit code showing on the
infotainment display and touch Pair. The
code on the cell phone and infotainment
display will need to be acknowledged for
asuccessful pair.
7. Start the pairing process on the cell
phone to be paired to the vehicle. See
the cell phone manufacturer's user guide
for information on this process. Once
the cell phone is paired, it will show
under Connected.
8. If the vehicle does not appear on your cell
p
hone, there are afew ways to start the
pairing process over.
•
Turn the cell phone off and then
back on.
•
Go back to the beginning
of the Phone menus on the
infotainment display and restart the
pairing process.
•
Reset the cell phone, but this step
should be done as alast-effort.
9. If the cell phone prompts to accept
connection or allow phone book download,
touch Always Accept and Allow. The phone
book may not be available if not accepted.
10. Repeat Steps 1−8 to pair additional
cell phones.
First Paired Phone Connected
If multiple paired cell phones are within the
range of the system, the system connects to the
paired cell phone that is set as First to Connect.
To enable apaired cell phone as the First to
Connect phone:
1. Make sure the cell phone is turned on.
2. Touch Settings, then touch System.
3. Touch Phones to access all paired and all
c
onnected cell phones and mobile devices.
4. Touch the edition icon to the right of
the cell phone to open the cell phone’s
settings menu.
5. Touch the First to Connect option, to enable
the setting for that device.
Cell phones and mobile devices can be added,
removed, connected, and disconnected. Asub-
menu will display whenever arequest is
made to add or manage cell phones and
mobile devices.
Secondary Phone
A phone can be enabled as aSecondary
Phone by touching the edition icon to the
right of the paired phone name to open
the phone settings menu. If aphone is
enabled as aSecondary Phone, it can connect
simultaneously alongside another Bluetooth
mobile device. In doing so, the Secondary
Phone will be labeled as Incoming Calls. This
means the mobile device can only receive calls.
The Address Book of aSecondary Phone will
not be available and hands-free outgoing calls
cannot be placed using this phone.