EasyManuals Logo

Chore-Time FLEX-AUGER 108 Installation Instruction

Default Icon
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
General Information FLEX-AUGER® Feed Delivery System
8
MA1032F
Glossary of Terms
The fill system may
be controlled by the
Drop Tube Switch
(left) or the Proxim-
ity Level Switch
(right). Both
switches are optional
and must be ordered
separately.
An Extension Boot (optional) may be used to provide addi-
tional length to a system. Multiple Extension Boots may be
used on very long systems.
An Outlet Drop is located at each outlet
opening along the FLEX-AUGER auger line.
very long systems.
The Control Unit
(right) is located at
the end of the fill
system. A Power
Unit (left) is secured
to the Control Unit
to turn the auger.
The Lower Boot Com-
ponents, located under
the feed bin, include a
bearing and feed
restrictor.
The 30 Degree Boot (left) is the standard boot used in single
bin applications.
The Straight-Out Boot (right) may be used in multiple bin
applications, elevated bins, and systems with less free flowing
feed stuffs.
The Auger Timer (optional)
is used to control the length
of auger run-time. It may be
used as a safety backup to
prevent excessive run time.
The 30 Degree Two
Motor Tandem Boot
(optional) is used when a
cross auger is required
under two feed bins. This
allows the feed bins to be
set at a 90 degree angle to
the FLEX-AUGER feeder
line.
The Hopper Level
Control is used to
control the feed level
in the hoppers.

Table of Contents

Other manuals for Chore-Time FLEX-AUGER 108

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Chore-Time FLEX-AUGER 108 and is the answer not in the manual?

Chore-Time FLEX-AUGER 108 Specifications

General IconGeneral
BrandChore-Time
ModelFLEX-AUGER 108
CategoryIndustrial Equipment
LanguageEnglish