EasyManuals Logo

Chore-Time FLEX-AUGER 108 Installation Instruction

Default Icon
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #28 background imageLoading...
Page #28 background image
Installation FLEX-AUGER® Feed Delivery System
28
MA1032F
Cover Plate Installation
1.Loosen Hex Nuts to the end of studs.
2.Start lower side of cover plate (Item 2) in boot opening.
3.Slide the cover plate up as far as possible so that plate catches top of boot opening.
4.Hold the cover securely while tightening the Hex Nuts.
DO NOT replaced lock nuts! Replacing them will violate CE compliance, & will void warranty and may
cause personal injury or even death!
Auger Brazing
If the auger needs to be spliced or lengthened, locate the brazed joint closer
to the power unit to minimize feed flow restriction in the line.
To align the auger for brazing, lay it in an 18” (46 cm) piece angle iron and
clamp securely.
Rotate the auger to allow both the inside and outside edges of the augers to
be brazed.
Butt the ends of the auger against each other. DO NOT SCREW ONE AUGER INSIDE THE OTHER--This
restricts the feed flow.
Lap the augers approximately 2” (50 mm), as shown in Figure 18.
A bronze, flux-coated rod is recommended. The joint should be well filled and smooth so that it does not wear
against the tube. Allow the joint to air cool.
Important!
Item Description
1 Lock Nut
2 Cover Plate
1
1
2
Figure 17.Cover Plate Installation
Key Description
1 2" [50 mm)
Figure 18.Cover Plate Installation

Table of Contents

Other manuals for Chore-Time FLEX-AUGER 108

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Chore-Time FLEX-AUGER 108 and is the answer not in the manual?

Chore-Time FLEX-AUGER 108 Specifications

General IconGeneral
BrandChore-Time
ModelFLEX-AUGER 108
CategoryIndustrial Equipment
LanguageEnglish