Milliohm Meter 16502 User’s Manual
5-18
string The error message string containing 80 characters max.
(10) Command: SYSTem:LOCal
Function: It releases 16502 REMOTE status.
Parameter: None
Return: None
(11) Command: SYSTem:PADR[:OFFSet] <NRf+>
Function: It sets or queries PADR OFFSET, the unit is in MOHM.
Parameter: <NRf+> | MINimum | MAXimum parameter is acceptable. Range:
-50.0(MIN) ~+50.0(MAX)
Return: The query returns <NR2>, the unit is in MOHM.
(12) Command: SYSTem:COMPDISP {OFF | ON | 0 | 1}
Function: It sets or queries test function screen (MEAS DISPLAY) comparator
result(HI/PASS/LO) enable or disable display.
Parameter: {ON(1)|OFF(0)}
Return: The query returns <NR1> 0 or 1.
Error Messages
Read error queue from remote interface:
SYSTem:ERRor?
Below is the format of error message (maximum 80 characters for an error string):
-102 “Syntax error”
Execution Error
0 No error
There is no error message exist at present.
-102 Syntax error
Invalid character exists in the command string, ex. SOUR:DRIVE,1
-104 Data Type error
The parameter is not defined in the command string.
-106 Illegal parameter value
The parameter type is error in the command string.
-202 Setting conflict
Ex. 1: Sending out *TRG or TRIGGER command when the trigger mode is external.
Ex. 2: Sending out *TRG or TRIGGER command when DRIVE=STBY.
-203 Data out of range
The data parameter exceeds the valid range, ex. SOUR:DRIVE 8
-211 Data stale
Invalid data
Ex.: Receiving READ? command when DRIVE=STBY.
-224 Self-test failed
The self-test executed via remote interface (*TST) is failed. In additon, there are
other test errors. Refer to *TST? command for the description of return format.
-225 Too many errors
More than 20 errors are occurred and the error queue is full. It will not store other
errors until some of them are deleted. The error queue will be cleared after powered
off or executing *CLS (clear state) command.
-226 Query INTERRUPTED
When the device is in sending data state, the sending data is interrupted due to device
change to receiving state after got the new command. The output buffer will be cleared.
To Next Page
Loading...
