11
Construct Your IntelliTRACE System
Security Levels & Password Screen
After you have initiated the intelliTRACE Panel
Network as instructed above, you may now take
the proper steps to begin to add Individual intel-
liTRACE panels to your system. They will appear
in the System Tree Pane on the left as well as in
the Panel List on the right.
Launch the intelliTRACE program.
You will be presented with the screen as seen
in Figure 2.
Before Adding or Editing a System, you must first
gain access to the program.
Select the Login button along the bottom of
the screen to gain access to the program. The
Login screen will appear requesting a password.
See Figure 3.
Should you wish to logout of the system, simply
select the Logout button.
Initial factory set passwords and their pre-defined accessibility & rights for the below levels of Security are:
Level Title Code Accessibility/Rights
4 Manager 999 All pages, all passwords & all Setpoints editing
3 Engineer 55 All pages, Engineer password & all Setpoints editing
2 Supervisor 20 Setpoints, Tuning & I/O Mapping Tabs editing
1 Operator 100 Setpoints Tab. Temperature Set Point editing
To change these passwords, access the Application Setup window by pressing the Configure Button at the bottom
of the Main Screen.
Enter the appropriate password and then hit OK to continue.
Figure 2
Figure 3
To Next Page
Loading...
