Need help?Do you have a question about the Chromalox 3101 and is the answer not in the manual?
General| Brand | Chromalox |
|---|---|
| Model | 3101 |
| Category | Controller |
| Language | English |
Check for shipping damage and unpack the controller carefully.
Configure hardware switches on the controller bottom for specific functions.
Set up sensor input type using dip switches #1, #2, and #3.
Instructions for panel mounting the controller, including cutout and clip usage.
Guidelines for proper and safe electrical wiring practices.
Key principles for organizing wires and minimizing electrical noise.
Overview of front panel buttons and display indicators for control.
How the controller displays Process Value and Setpoint during normal operation.
Steps to enter Setup Mode and navigate through pages and menus.
Procedure to access the controller's setup configuration.
How to navigate between different parameter pages using buttons.
Method for choosing specific parameters within a selected page.
Configure limit control parameters like setpoints and deadbands.
Setup page for configuring sensor input types and units.
Configure settings for the first alarm output.
Procedure to acknowledge and reset the limit output relay.
Methods to reset the limit output and LED after an alarm.
Different modes for alarm activation (High, Low, Deviation).
Configuration of mode, baud rate, and address.
Crucial precautions and requirements before calibrating.
Procedure to calibrate the sensor input using simulators.
Steps to calibrate the analog output signal.
Range and accuracy details for various input types.
To Next Page
