Chrysler Stratus RHD 1999 - Compressor Clutch;Coil Assembly

(2) Loosen and remove drive belt (Fig. 15). Refer to
Group 7, Engine Cooling.
(3) Disconnect compressor clutch wire lead.
(4) Recover refrigerant system with R-134a recov-
ery unit.
(5) Remove refrigerant lines from compressor (Fig.
16).
(6) Remove compressor attaching bolts (Fig. 17)
and (Fig. 18).
(7) Remove compressor (Fig. 19).
INSTALLATION
(1) Position the compressor on the mount.
(2) Install the compressor attaching bolts. Tighten
bolts to 41 N·m (30 ft. lbs.) torque.
(3) Install drive belt (refer to Group 7, Cooling
System).
(4) Install refrigerant hoses and new seals.
(5) Connect the clutch wire.
(6) Charge the system.
(7) Connect the negative cable to the battery.
COMPRESSOR CLUTCH/COIL ASSEMBLY
REMOVAL
(1) Remove the compressor from the mount.
Fig. 14 Blower Motor Resistor
Fig. 15 Drive Belt
Fig. 16 A/C Lines
Fig. 17 Lower Attaching Bolts
Fig. 18 Upper Attaching Bolts
24 - 14 HEATING AND AIR CONDITIONING JA
REMOVAL AND INSTALLATION (Continued)