LEFT UNDER INSTRUMENT PANEL SILENCER/
DUCT
REMOVAL
(1) Remove two lower knee bolster screws and slip
silencer off outboard attaching formation.
(2) Maneuver part off of center floor distribution
duct to remove.
INSTALLATION
For installation, reverse the above procedures.
Install prior to knee bolster.
MASK/LENS
REMOVAL
Remove mask/lens retaining screws and remove
mask/lens (Fig. 7).
INSTALLATION
For installation, reverse the above procedures.
ODOMETER/TRANSMISSION RANGE
INDICATOR
REMOVAL
(1) Remove speedometer/tachometer, refer to
Speedometer/Tachometer and Odometer Transmis-
sion Range Indicator Removal and Installation
(2) Remove screws attaching from the back of
speedometer and remove the odometer/transmission
range indicator display (Fig. 13).
INSTALLATION
For installation, reverse the above procedures.
RADIO
For Radio removal procedures, Refer to Group 8F,
Audio Systems.
RIGHT UNDER INSTRUMENT PANEL
SILENCER/DUCT
REMOVAL
(1) Remove push-in fastener under right end of
instrument panel.
(2) Maneuver part off center floor distribution duct
to remove.
INSTALLATION
For installation, reverse the above procedures.
SPEEDOMETER/TACHOMETER AND ODOMETER
TRANSMISSION RANGE INDICATOR
REMOVAL
(1) Remove mask/lens retaining screws and
remove mask/lens (Fig. 7).
(2) Disconnect odometer/transmission range indi-
cator connector from the printed circuit board (Fig.
8).
(3) Remove screws attaching speedometer/tachom-
eter to housing and remove (Fig. 9).
(4) Remove screws attaching from the back of
speedometer and remove the odometer/transmission
range indicator display (Fig. 13).
INSTALLATION
For installation, reverse the above procedures.
VEHICLE THEFT SECURITY SYSTEM LED
REMOVAL
(1) Disconnect Vehicle Theft Security System LED
socket assembly indicator from the printed circuit
board (Fig. 5).
(2) Rotate LED socket counter clockwise and
remove from printed circuit board (Fig. 8).
INSTALLATION
For installation, reverse the above procedures.
Fig. 12 Top Cover
Fig. 13 Odometer/Transmission Range Indicator
JA INSTRUMENT PANEL AND SYSTEMS 8E - 9
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
