Chrysler Stratus RHD 1999 - Center Bezel; Cigar Lighter; Power Outlet; Cluster Hood; Cluster Lamp

INSTALLATION
For installation, reverse the above procedures.
CENTER BEZEL
REMOVAL
Pull center bezel straight rearward along the sides
of the radio and A/C control openings to disengage
four clips (Fig. 3).
INSTALLATION
For installation, reverse the above procedures.
CIGAR LIGHTER / POWER OUTLET
REMOVAL
(1) Remove cubby bin. Refer to Cubby Bin / Lamp
Removal and Installation in this section.
(2) Disconnect the two power outlet wiring connec-
tors from power outlet. Unscrew shell and clamp
assembly to replace power outlet.
INSTALLATION
For installation, reverse the above procedures. The
clamp has a locating feature. The cubby bin must
engage the console at its forward edge prior to
installing the mounting screws.
CLUSTER HOOD
REMOVAL
(1) Remove instrument panel left end cap.
(2) Tilt steering column down to its lowest posi-
tion.
(3) Remove instrument panel center bezel by dis-
engaging the four clips (Fig. 3).
(4) Remove instrument cluster hood (Fig. 4).
(a) Remove three attaching screws under the
center bezel.
(b) Remove screw at left end of panel.
(c) Pull hood straight back to disengage the
eight clips. If equipped with a Compass/Tempera-
ture Mini Trip Computer pull rearward about 3
inches and stop. Reach through the radio opening
in the cluster hood and disconnect the CMTC wire
connector.
(d) Remove the cluster hood.
INSTALLATION
For installation, reverse the above procedures.
Keep the forward edge of the hood down on the
instrument panel while sliding the hood forward to
engage the retaining clips.
CLUSTER LAMP
Refer to (Fig. 5) for appropriate lamp locations.
Replace fog lamp indicator lamp, ABS indicator lamp
and security LED socket assembly only if equipped.
CLUSTER PRINTED CIRCUIT BOARD
REMOVAL
(1) Remove six cluster back cover retaining screws
and remove the cover.
(2) Disconnect odometer/transmission range indi-
cator connector from the printed circuit board.
(3) Remove nine printed circuit board attaching
screws and remove. There are two screws located at
the base of each connector (Fig. 6).
INSTALLATION
For installation, reverse the above procedures.
Fig. 3 Center Bezel
Fig. 4 Instrument Cluster Hood
8E - 4 INSTRUMENT PANEL AND SYSTEMS JA
REMOVAL AND INSTALLATION (Continued)