CUBBY BIN/LAMP
REMOVAL
(1) Remove center bezel.
(2) Remove instrument cluster hood screws.
(a) Remove two screws adjacent radio.
(b) Remove screw below HVAC control in the
center.
(c) Remove screw at left end of panel.
(d) Flex instrument cluster hood slightly to give
access to the cubby bin screws.
(3) Remove the cubby bin mounting screws and
remove bin.
INSTALLATION
For installation, reverse the above procedures. The
cubby bin must engage the console at its forward
edge prior to installing the mounting screws.
FUEL GAUGE AND TEMPERATURE GAUGE
REMOVAL
(1) Remove mask/lens retaining screws and
remove mask/lens (Fig. 7).
(2) Disconnect odometer/transmission range indi-
cator connector from the printed circuit board (Fig.
8).
(3) Remove screws attaching speedometer/tachom-
eter to housing and remove (Fig. 9).
(4) Remove the fuel/temperature gauge attaching
screws from the housing and remove (Fig. 10).
INSTALLATION
For installation, reverse the above procedures.
GLOVE BOX DOOR HANDLE
REMOVAL
(1) Open glove door.
(2) Remove four door handle attaching screws.
(3) Remove handle.
INSTALLATION
For installation, reverse the above procedures.
Fig. 5 Lamp Location
Fig. 6 Printed Circuit Board
JA INSTRUMENT PANEL AND SYSTEMS 8E - 5
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
