INSTALLATION
For installation, reverse the above procedures. Ver-
ify that the cables are properly adjusted and the
module is seated properly.
CABLE ADJUSTMENT
The cables must be adjusted for proper function of
the control module. To adjust the cable, attach the
cable to the lever arm of the control module. Turn
the knob fully counterclockwise. Pull the cable jacket
away from the cable end until taut. Clip the cable
jacket to the control module. The knob should travel
a full 180° if the cable is properly adjusted.
DISCHARGE LINE
REMOVAL
(1) Remove refrigerant from the A/C system using
a refrigerant recovery machine.
(2) Disconnect A/C pressure transducer wire har-
ness.
(3) Remove quick connect clip and disconnect quick
connect at condenser using Special Tool kit 7193 (Fig.
32) and (Fig. 33).
CAUTION: Cap all lines that are not being replaced
and cap the expansion valve tubes.
Fig. 29 Control Module
Fig. 30 Control Module Screws
Fig. 31 Control Module At Bezel Opening
Fig. 32 Quick Connect Clip
Fig. 33 Special Tool For Line At Condenser
24 - 18 HEATING AND AIR CONDITIONING JA
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
