GLOVE BOX DOOR LOCK
REMOVAL
(1) Remove glove box door handle.
(2) Insert the proper key in lock cylinder, depress
the gray locking key on back side housing at the 3
O’clock position.
(3) Rotate the key clockwise to disengage cylinder
from housing.
INSTALLATION
For installation, reverse the above procedures.
HVAC CONTROL
REMOVAL
(1) Remove center bezel by pulling rearward to
disengage four clips and remove attaching screws
from cubby bin (Fig. 3).
(2) Remove the HVAC control attaching screws.
Pull the control out to disconnect two electrical con-
nectors and two control cables. Remove HVAC con-
trol.
INSTALLATION
For installation, reverse the above procedures. The
forward edge of bin must engage the forward console.
INSTRUMENT CLUSTER
REMOVAL
To service any instrument cluster component, the
instrument cluster must be removed from the instru-
ment panel.
(1) Remove instrument cluster hood, refer to Clus-
ter Hood Removal and Installation procedures.
(2) Remove the four cluster attaching screws (Fig.
7).
(3) Remove instrument cluster and disconnect wire
connectors from instrument panel by pulling cluster
rearward.
INSTALLATION
For installation, reverse the above procedures.
Fig. 7 Mask/Lens Retaining Screws
Fig. 8 Back Cover Retaining Screws
Fig. 9 Speedometer/Tachometer
Fig. 10 Fuel Gauge and Temperature Gauge
8E - 6 INSTRUMENT PANEL AND SYSTEMS JA
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
