REAR SPEAKER
CAUTION: Do not operate the radio with speaker
leads detached. Damage to the output devices may
result.
The wire connectors can be accessed through the
trunk.
REMOVAL
(1) Remove parcel shelf panel, refer to Group 23,
Body.
(2) Remove four retaining screws (Fig. 10).
(3) Disconnect wire connector and remove speaker.
INSTALLATION
For installation, reverse the above procedures. Be
sure that the wire connectors are facing outward in
vehicle.
REMOTE AMPLIFIER
REMOVAL
(1) Remove the right front seat.
(2) Remove the two screws and one nut attaching
the amplifier (Fig. 11).
(3) Disconnect the electrical connectors and
remove.
INSTALLATION
For installation, reverse the above procedures.
Tighten fasteners to 4 N·m (40 in. lbs.) torque.
REMOTE CD CHANGER
REMOVAL
(1) Turn ignition switch to the OFF position.
(2) Remove the instrument cluster hood. Refer to
Group 8E, Instrument Panel and Systems for
removal procedures.
(3) Remove the two CD changer attaching screws
located under the HVAC control.
(4) Slide the CD changer/power outlet assembly
rearward in the vehicle.
(5) Disconnect CD DIN cable, power outlet, and
the light socket assembly wire connectors.
(6) Remove the CD changer.
(7) Remove mounting bracket and power outlet
from cd changer. Transfer to new unit if replacing
changer.
INSTALLATION
For installation, reverse the above procedure. Be
sure to index rear tab on changer mounting bracket
into slot in vehicle mounting bracket.
Fig. 10 Rear Speakers
Fig. 11 Amplifier Location
JA AUDIO SYSTEMS 8F - 17
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
