(3) Tighten the adjusting screw until belt is ten-
sioned to specifications. Refer to Belt Tension Chart
for specifications.
(4) Tighten idler pulley locking bolt to 54 N·m (40
ft. lbs.). Recheck belt for proper tension and adjust as
necessary.
(5) Install power steering pump drive belt.
Air Conditioning and Generator Belt Tension Adjustment
To adjust the air conditioning and generator drive
belt, loosen the idler pulley locking bolt and adjust
belt tension by turning adjusting screw (Fig. 49). Use
Belt Tension Gauge and refer to Belt Tension Chart
for specification. Tighten pulley bolt to 54 N·m (40 ft.
lbs.) after adjustment.
POWER STEERING PUMP BELT
REMOVAL
(1) From the top of the vehicle loosen pivot bolt
(Fig. 51).
(2) Hoist vehicle and remove splash shield (Fig.
50).
(3) From under the vehicle loosen the locking bolts
F and G (Fig. 51).
INSTALLATION
(1) Install belt. Refer to (Fig. 48) for belt routing.
NOTE: Use Special Tool 7198, Belt Tension Gauge
to check belt for proper tension.
(2) Adjust belt tension with 1/2 in. drive breaker
bar installed in adjusting bracket (Fig. 51). Use belt
tension gauge and refer to Belt Tension Chart for
tension specification.
Fig. 47 Power Steering Belt Adjustment
BELT TENSION CHART
ACCESSORY DRIVE
BELTS
GAUGE
2.0/2.4L ENGINES
Air Conditioning
Compressor &
Generator
New
Belt:
667 N (150 lbs.)
Used
Belt:
356 N (80 lbs.)
Power Steering Pump
New
Belt:
578 N (130 lbs.)
Used
Belt:
356 N (80 lbs.)
Fig. 48 Accessory Drive Belt Routing—2.5L Engine
Fig. 49 Air Conditioning Compressor and Generator
Belt Idler
JA COOLING SYSTEM 7 - 29
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
