CHIME WARNING / REMINDER SYSTEM
CONTENTS
page page
GENERAL INFORMATION
INTRODUCTION ......................... 1
DESCRIPTION AND OPERATION
DOOR AJAR CHIME ...................... 2
EXTERIOR LAMPS LEFT ON ............... 2
FASTEN SEAT BELTS ..................... 2
KEY LEFT IN IGNITION SWITCH ............ 2
DIAGNOSIS AND TESTING
CHIME DIAGNOSTIC CONDITIONS .......... 2
REMOVAL AND INSTALLATION
BODY CONTROL MODULE (BCM) ........... 3
HEADLAMP SWITCH ..................... 3
JUNCTION BLOCK (JB) ................... 3
KEY-IN SWITCH ......................... 3
SEAT BELT BUCKLE ...................... 3
GENERAL INFORMATION
INTRODUCTION
WARNING: ON VEHICLES EQUIPPED WITH AN AIR-
BAG, REFER TO THE AIRBAG PORTION OF THIS
SECTION FOR STEERING WHEEL OR SWITCH
REMOVAL AND INSTALLATION PROCEDURES.
The chime warning/reminder system includes sig-
nals for fasten seat belts, exterior lamps left ON, key
left in ignition and door ajar (Fig. 1).
Use the DRB lllt scan tool and the proper Body
Diagnostic Procedures Manual.
FASTEN SEAT BELTS
A warning lamp on the instrument panel, and an
audible chime tone are used as the fasten seat belt
warning/reminder.
EXTERIOR LAMPS LEFT ON
An audible chime tone that indicates the exterior
lamps were left on.
KEY LEFT IN IGNITION
An audible chime tone that indicates the key was
left in ignition.
Fig. 1 Chime Warning / Reminder System Wiring
JA CHIME WARNING / REMINDER SYSTEM 8U - 1
To Next Page
Loading...
