hose. If no washer spray, check fluid hoses kinks or
leaks (Fig. 9).
WASHER RESERVOIR
REMOVAL
(1) Disconnect washer fluid hose at in-line connec-
tor on top of the right shock tower.
(2) Partially remove bumper fascia as needed to
gain access to the reservoir. Refer to Group 23, Body.
(3) Disconnect wire connector from washer pump
and harness mounting tab (Fig. 10).
(4) Slide rearward and drop down and away from
vehicle.
(5) Drain washer fluid from reservoir into an
appropriate container.
(6) Disconnect the washer hose from the reservoir.
INSTALLATION
For installation, reverse the above procedures.
WASHER RESERVOIR PUMP
REMOVAL
(1) Partially remove the bumper fascia as needed
to gain access to the reservoir pump. Refer to Group
23, Body.
(2) Place a drain bucket below the reservoir to
catch any washer solvent that may leak out.
(3) Firmly grasping pump by hand twist and pull
away from reservoir and out of grommet. Care must
be taken not to puncture reservoir (Fig. 11).
(4) Remover rubber grommet from reservoir and
throw away.
INSTALLATION
For installation, reverse the above procedures. A
new grommet is required for installation. Refill res-
ervoir with the washer solvent.
Fig. 8 Multi-Function Switch
Fig. 9 Washer Fluid Hose Location
Fig. 10 Reservoir Removal
Fig. 11 Washer Pump
8K - 8 WINDSHIELD WIPERS AND WASHERS JA
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
