(6) Remove three bolts attaching starter to trans-
mission housing and remove starter from vehicle.
INSTALLATION
For installation, reverse the above procedures.
Clean corrosion/dirt from wire terminals before
installing wiring to the solenoid.
STARTER RELAY
The relay is located in the Power Distribution Cen-
ter (PDC). Refer to the PDC cover for relay location.
SPECIFICATIONS
STARTER
Manufacturer BOSCH MELCO NIPPONDENSO
Engine 2.0L 2.5L 2.4L
Application
Power
rating
0 .95 Kw 1.2 Kw 1.4 Kw
Voltage
12 VOLTS
12 VOLTS 12 VOLTS
Brushes 4 4 4
Drive Planetary Planetary Offset Gear
Gear
Train
Gear
Train
Reduced
Engine Amperage Draw Test ……150-280 Amps*
Engine should be up to operating temperature.
Extremely heavy oil or tight engine will increase
starter amperage draw.
TORQUE
DESCRIPTION TORQUE
Starter Mounting Bolts .......54N·m(40ft.lbs.)
Starter Solenoid Battery Nut . . . 10 N·m (90 in. lbs.)
Fig. 9 Wire Terminal Connection – 2.5L Engine
8B - 8 STARTING SYSTEMS JA
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
