(3) Tighten locking bolt G to 28 N·m (250 in. lbs.)
(Fig. 51).
(4) Tighten locking bolt F and the pivot bolt to 54
N·m (40 ft. lbs.).
Power Steering Pump Belt Tension Adjustment
Refer to Power Steering Pump Belt installation
procedures for belt tensioning procedures.
CLEANING AND INSPECTION
WATER PUMP—2.0/2.4L ENGINES
Replace water pump body assembly if it has any of
these defects:
(1) Cracks or damage on the body.
(2) Coolant leaks from the shaft seal, evident by
coolant traces on the pump body.
(3) Loose or rough turning bearing.
(4) Impeller rubs either the pump body or the
engine block.
(5) Impeller loose or damaged.
(6) Sprocket or sprocket flange loose or damaged.
WATER PUMP—2.5L ENGINE
Replace the water pump if it has any of the follow-
ing defects:
• Damage or cracks on the pump body.
Fig. 50 Accessory Drive Belt Splash Shield
Fig. 51 Power Steering Belt Adjustment
BELT TENSION CHART
ACCESSORY DRIVE
BELTS
GAUGE
2.5L ENGINE
Air Conditioning
Compressor &
Generator Belt
New
Belt:
667 N (150 lbs.)
Used
Belt:
356 N (80 lbs.)
Power Steering Pump
Belt
New
Belt:
578 N (130 lbs.)
Used
Belt:
356 N (80 lbs.)
Fig. 52 Water Pump Inspection
7 - 30 COOLING SYSTEM JA
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
