3-4 Turning Up the System
3902 Service Delivery Switch Hardware Installation and Start-up Manual
009-3205-001 Standard Revision D
Copyright
©
2013-2015 Ciena
®
Corporation July 2015
For a procedure see “Configuring the Remote Management Interface” on
page 3-10.
Accessing the CLI Using Telnet
Once the remote interface is configured with a valid IP address, you can
access the device through Telnet.
The Telnet client must have a route set up to allow access to the device. See
step 3 of “Configuring the Remote Management Interface” on page 3-10.
Note: A maximum of 10 Telnet sessions can be connected at the same
time.
For a procedure see “Accessing the CLI Using Telnet” on page 3-11.
Configuring an Interface using DHCP
DHCP can be used for automatic configuration on IP networks. By default,
DHCP is enabled to run on the remote interface. When DHCP is disabled,
static IP addresses must be assigned for all interfaces. When DHCP is
enabled, you have the option of using it to configure the remote interface or
the local interface, but not both. The interface that is not using DHCP must
have a static IP address.
If the interface is running DHCP, the DHCP server assigns an IP address and
you cannot access the static IP address you configured on the interface.
Even if you are running DHCP on an interface, you may want to manually
configure the interface so that there is a valid static IP address defined for the
interface when DHCP is not running. To manually configure a remote
interface, see “Configuring the Remote Management Interface” on page 3-10.
Note: Ensure DHCP is disabled while you are configuring the remote or
local interface.
Note: The local interface is only available on the 3920, 3930, 3940, 3960
and 5150. The other devices in the product family do not have a local
interface and have a remote interface only.
For a procedure see “Configuring an Interface using DHCP” on page 3-12.
Setting the System Host Name
The system host name is a string used to uniquely identify the system. The
system host name replaces the default user prompt with a user-defined name.
The host name can be set manually, through DHCP, or through SNMP.
To Next Page
Loading...
