Ciena 3902 - Turning up the System

3-1
3902 Service Delivery Switch Hardware Installation and Start-up Manual
009-3205-001 Standard Revision D
Copyright
©
2013-2015 Ciena
®
Corporation July 2015
Turning Up the System 3-
This chapter contains procedures to assist with the initial configuration of the
3902, including the following:
• “Logging in through the Serial Console Port”
• “Creating a New User Account”
• “Deleting a User Account”
• “Managing Licenses”
• “Configuring the Remote Management Interface”
• “Accessing the CLI Using Telnet”
• “Configuring an Interface using DHCP”
• “Setting the System Host Name”
• “Logging out of the system”
For information on managing system software, including performing software
upgrades, see 39XX/51XX Software Management and Licensing.
Logging in through the Serial Console Port
On 3902 switches, the serial console port requires a null modem cable
connected to a male DB-9 to male RJ-45 cable to connect to the RJ-45
connector.
Before you begin, ensure that the 3902 is powered on.
For information on provisioning commands for the serial-console interface,
see 39XX/51XX Command Reference.
For a procedure see “Logging in through the Serial Console Port” on page 3-6.
Creating a New User Account
The 3902 is preconfigured with default user accounts. The default user
accounts are common to all Ciena Carrier Ethernet products and are not
confidential. When you turn-up the system you need to configure new user
accounts and delete the default accounts in order to protect the system.