CIGWELD Transmig 310 - Page 3

Transmig 210, 250, 310, 33
CONTENTS
Page
Page 2 of 31 DOC No: MIGTRN0001
Date: 14/09/98 Issue No: 2
7.3 MIG Torch Components.........................................................................................................................21
7.4 Installing A New Conduit Liner...............................................................................................................22
7.5 MIG Torch Maintenance.........................................................................................................................22
8. BASIC WELDING TECHNIQUE.......................................................................................23
8.1 Setting of the Power Source & Wirefeeder...............................................................................................23
8.2 Position of MIG Torch............................................................................................................................23
8.3 Distance from the MIG Torch Nozzle to the Work Piece..........................................................................23
8.4 Travel Speed...........................................................................................................................................23
8.5 Stitch Welding Operation........................................................................................................................23
8.6 Spot Welding Operation..........................................................................................................................24
9. ROUTINE MAINTENANCE & INSPECTION..................................................................24
9.1 Improved Current Accuracy Calibration Procedure for the Digital Meter..................................................25
10. BASIC TROUBLESHOOTING.........................................................................................26
10.1 Solving Problems Beyond the Welding Terminals..................................................................................26
10.2 Welding Problems.................................................................................................................................28
10.3 Power Source Problems.........................................................................................................................29
10.4 Key Spare Parts....................................................................................................................................31