EL DC Instalation and operation manual v13.docx
21 / 56
3.3.3. Transport to location
The equipment includes castors to facilitate its transport to its final location.
It is important to check previously if the weight of the converter is appropriate for the site where
it will be located.
It is also important to consider the most suitable means to place the converter in its final location
(floor, hoist, lift, stairs, etc…).
3.3.4. Location
It is necessary to leave a minimum of 25 cm in the contour of the equipment for its ventilation.
If possible, as shown in following figures, it is recommended to leave additional 75 cm to
facilitate the operations of maintenance of the equipment or the interventions of the technical
service in case of breakdown.
Front view:
To Next Page
Loading...