50 / 56
- Remote: using Modbus Ethernet (IP) or serial port.
- Console: analogue control.
- F: In some scenarios, the control system interacts with the active harmonic
compensation of the equipment under test. When that happens, the control system
can be unstable. Due to the converter’s design, limiting the bandwidth of the control
algorithm can help to stabilize the plant and move forward with the tests. Another
option is to limit the speed of the application of the load. In the ramp section, a ramp
can be programmed from 0.001 to 100 Units per millisecond.
- G: Connection settings.
7.1. Alarm
In this tab, the alarm status of each converter is shown. When there is an alarm, the light turns
to red.
To Next Page
Loading...