EasyManua.ls Logo

Cinergia B2C10 - Page 45

Cinergia B2C10
56 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EL DC Instalation and operation manual v13.docx
45 / 56
- A: Actual IP is shown.
- B: Write the new IP below and send it. After around 30 seconds, the interface will turn
blue, which means that is disconnected from the old IP. Connect with the equipment
again (Operation tab) with the new IP. If necessary, look at the LCD local screen in order
to make sure that the new IP is correct.
Drivers x6 Drivers x6
Current
sensor x3
Voltage
sensor x2
Voltage
sensor x3
Current
sensor x3
Voltage
sensor x3
PE
-U
-U
PE
PE
EMC
filter
EMC
filter
AC output
PE
EL
U
DSP
board
DSP
board
CAN/
Ethernet
board
CAN
MODBUS/TCP
ETHERNET
V
W
N
PE
R
S
T
N
PE
This Modbus TCP slave has the following properties:

Table of Contents