X1 Series Dental Unit -Operating Manual
Add: Building 6-1,Nansha Industrial Village Jiangli North Rd,Danzao Town, Nanhai District,Foshan ,Guangdong,China
www.cingol.com
Handpieces can be operated without coolant.
Tooth substance can be damaged by frictional heat.
Always make sure that the treatment area does not overheat
whenever you switch the coolant off.
Over-tensioning or pinching the hoses may cause the media pipes to
leak. Ensure that you do not pull or bend the instrument hoses too much.
4.4.4 Placing the instruments in their holders
Every handpiece has a corresponding switch on the holder. When the
handpiece is removing to their holder, the switch will open the pile-up
valve and the removed handpiece is unlocked.
Therefore, always make sure that all handpieces are placed in the
correct instrument holders. If any handpieces are placed in the wrong
holders, the removed handpieces will not be activated.
4.4.5 Operating the handpieces
See “4.2 Foot Control”.
Also observe the Operating Manual of the handpiece.
4.4.6 Adjusting the handpieces’ working air pressure and water flow
The handpieces’ working air pressure and cooling water flow can be
adjusted by their adjust valves. The control valves are shown in the
following illustration.
Top mounted Hanging Type /Cart Type
To Next Page
Loading...