IV
The 8000 Series is intended for enterprise logistics use, however, it may do damage to the mobile
computer when being exposed to high temperatures or soaked wet.
When the body of the mobile computer gets dirty, use a clean and wet cloth to wipe off the dust. DO
NOT use/mix any bleach or cleaner. Always keep the LCD dry.
For a liquid crystal display (LCD), use a clean, non-abrasive, lint-free cloth to wipe dust off the screen.
DO NOT use any pointed or sharp object to move against the surface.
Battery disposal – For green-environment issue, it is important that batteries should be recycled in a
proper way.
If you want to put away the mobile computer for a period of time, download the collected data to a host
computer, and then take out the battery pack. Store the mobile computer and battery pack separately.
When the mobile computer resumes its work, the main and backup batteries will take a certain time to
become fully charged.
If you shall find the mobile computer malfunctioning, refer to the Troubleshooting section for self help
first.
If the problem persists, write down the specific scenario and consult your local sales representative.
Below are instructions of how to have the 8000 Series ready to work. This scenario makes use of a cradle,
which may be replaced by the 4-slot battery charger or other specified interface to PC.
Set up the cradle for initial charging.
Install the battery pack to the mobile computer, and then seat the mobile computer in the cradle for
charging.
When charging is done, turn on the mobile computer and enter the System Menu for system
configuration, downloading programs and font file, and so on.
Before downloading, you must connect a serial cable between the cradle and a host computer.
Refer to the System Menu > 6. Load Program for more information.
After charging and downloading, the mobile computer is ready for use. Install the hand strap if
necessary.
Care & Maintenance
Getting Started
To Next Page
Loading...
Need help?
General
