CipherLab 8230 User Manual

71
Appendix III 2D Scan Engine
SYMBOLOGY SETTINGS TABLE
1D SYMBOLOGIES
2D Engine
Description
Default
Codabar Enable
Tran
smit Start/Stop
Character
Decide whether to include the start/stop characters in the
data being transmitted.
No
Select Length
 Any Length
 One or two fixed lengths
 Range (1~55)
Any Length
Code 128 Enable
GS1-128 Enable
Replace Field
Separator
Decide whether to replace the field separator.
If the
barcode contains Field Separator “0x1D”
, it will be
changed to the desired Field Separator. F
or example, type
the desired character “;” (semicolon) as the new field
separator. Then if the barcode contains Field Separat
or
“0x1D”, it will be changed to “;”.
No
ISBT 128 Enable
Industrial 25 (Discrete 25) Enable
Select Length
 Any Length
 One or two fixed lengths
 Range (1~55)
Any Length
Interleaved 25 Enable
Convert to EAN-13 Convert a 14-character barcode into EAN-
13 if the
following requirements are met:
 The barcode must have a leading 0 and a valid EAN-
13
check digit.
No
Verify Check Digit Decide whether to verify the check digit
. If desired, select
one of the algorithms below. If the check digit
is incorrect,
the barcode will not be accepted.
 No
 USS algorithm
 OPCC algorithm
No
Transmit Check Digit Decide whether to include the check digit
in the data being
transmitted.
No
Select Length
 Any Length
 One or two fixed lengths
 Range (1~55)
Any Length

CipherLab 8230 Specifications

General

Brand	CipherLab
Model	8230
Category	Handhelds
Language	English