1.2 SHORT DESCRIPTION
The Wallbox eHOME charging system is specially designed to be easily installed both
in outdoor and indoor private car parks, in order to charge all the EV brands of the
market in MODE 3 (according to European standard IEC 61851-1), by just connecting
either its tethered cable with a type 1 or type 2 connector.
2 MAIN FEATURES
• Remote control input: Allows to start/stop the EV charge by means of a
dedicated logic input.
• Plug & Play: It is possible to start charging by just plugging the Wallbox
eHOME connector into the car.
• Current limitation: By means of an on-board rotate dipswitch, the maximum
current delivered by the unit is setup.
• Status RGB LED bar: It shows the status of the unit when it is either available
or charging. Also some specific blinking error sequences are shown when there
is a faulty operation.
• Housing: Designed for outdoor and indoor operation.
3 FIRMWARE VERSION
When the unit is booting, the LED bar will show the firmware version in orange. The
first digit of the version will be shown as a certain number of blinking of the first LED, as
many times as the digit indicates, and the second digit will be displayed by the last LED
blinking accordingly to what the second digit indicates (i.e. for version 1.6, you will see
one blink at the first LED and six at the last LED).
To Next Page
Loading...
