Circutor AFQm 30 A - Cabinet-Type AFQm Terminals (70-280 A)

27
Instruction Manual
AFQm
11
Figure 19:AFQm cabinet-type earth terminal.
Table 14:List of terminals.
Device terminals
1: S1, Current input L1 6: S2, Current input L3
2: S2, Current input L1 7: L1, Mains connection L1
3: S1, Current input L2 8: L2, Mains connection L2
4: S2, Current input L2 9: L3, Mains connection L3
5: S1, Current input L3 10: N, Mains connection N
11: Earth connection
3.6.4.- CABINETTYPE AFQm: AFQm-xxx-070C, AFQm-xxx-140C, AFQm-xxx-210C AND AFQm-xxx-
280C
There are sliding windows at the bottom of the cabinet so that the connection wiring can be slotted
inside, Figure 14. These windows can be removed and machined if it is considered necessary to use a
cable gland.
You should never remove the cover closest to the front part.
The current input and the communication ports must be connected to the “master” device, which is
the located at the top of the cabinet. This connection is described in “3.6.2.- RACK-TYPE AFQm: AFQm-
xxx-100R”.
To access the current input and mains connections, loosen the screws in the lower front cover Figure
20.
30