49
Instruction Manual
AFQm
Table 21 (Cont.) : Status messages
Status messages
Calibration
Description Calibrating the internal sensors.
Configuration
Description Configuring the device.
Run
Description Device is operating.
Sync
Description The AFQm is synchronising with the mains.
Charging Bus DC
Description Charging process of the internal bus prior to start-up.
Stop
Description Device stopped.
Alarm
Description
An alarm has been generated.
Access the Alarms screen (“6.16.ALARMS”) to obtain more information.
6.1.2. - DEVICE SLAVE
In Figure 43 the main screen of the “slave” device is shown.
Status messages
RUN / STOP key
RESET key
Figure 43: Main screen of the slave device.
This shows the % for the filter power used.
The and / keys are disabled in the slave devices.
Use the and keys to navigate through the different display screens.
In the upper part of the screen, a message with the current status of the device is shown (Table 21).
To Next Page
Loading...