67
Instruction Manual
AFQm
● Type, device range:
30A: 30 A model.
60A: 30 A model.
70A: 70 A model.
100A: 100 A model.
Press the key to access the next configuration step
Press the key to access the main screen of the device without saving the configuration values.
7.3.- INSTALLED DEVICES
The type of device are configured in this screen, Figure 72.
Figure 72: Configuration screen: Installed units
● Type of device: Master / Single / Slave
In this screen the type of device is selected, the possible options are:
Single: select this option if the AFQm does not have filters connected in parallel.
Master: select this option if the filter is going to be used as the “master” of a group of devices
in parallel.
Slave: select this option if the device is going to be used as the “slave” of a group of devices
in parallel.
Once the device has been configured as the “slave”, the next configuration step is shown in
section “6.19.- ETHERNET COMMUNICATIONS”.
Note: The and / keys are disabled in the slave devices.
Press the key to access the next configuration step
Press the key to access the main screen of the device without saving the configuration values.
To Next Page
Loading...