Circutor AFQm 30 A - Slave Device Status Display

To Next Page

To Previous Page

Instruction Manual

AFQm

Figure 65: Calibrate touch sensor.

Note: You have accessed the calibration screen by accident, wait until the line that surrounds the

central circle is complete and you will be returned automatically to the information screen of the

device (Figure 64).

Use the and keys to navigate through the different display screens.

6.21.- SLAVE DEVICE STATUS

Note: This screen is not visible on the “slave” devices.

Note: This screen is only displayed if a system has been configured with devices in parallel.

This screen, Figure 66, shows the status of each “slave” device.

Figure 66: Slave device status screen (1).

The “slave” to be checked can be selected from the top tab, by serial number.

Select the “slave”; the screen shown in Figure 67 will be displayed. This screen shows the Model, Type

and Serial number of the device, as well as its status, active alarms and the temperature of the IGBTs

and inductors.