97
Instruction Manual
AFQm
4 Disconnect the flat belts, Hall-effect sensors and fans.
4
4
Figure 97:AFQm-xxx-100R Change of cooling fans (Step 4).
5 Remove the 4 screws from the board bracket and carefully disassemble the boards. Remove the
wall bushing from the fan cables to allow disassembly.
4
6 Remove the screws from the driver board.
25
7 Remove the driver board by gently pulling upwards.
8 Remove the screws from the bars ( 5), along with the screws in the end of the inductance.
(type 5 and 10mm).
5
8
8
6
Figure 98:AFQm-xxx-100R Change of cooling fans (Step 5, 6, 8).
9 Remove the 3 screws from the fans.
To Next Page
Loading...