Using the Cisco SPA 500S Attendant Console
Configuring the Cisco SPA 500S
Cisco Small Business Pro IP Phone SPA 50X User Guide (SIP) 85
6
Configuring the Cisco SPA 500S
The Cisco SPA 500S can be configured to easily access other phone lines in the
system. For example, buttons on the Cisco SPA 500S can be configured to monitor
another extension, speed dial a number, transfer calls to another extension, and
more.
NOTE The options available on the Cisco SPA 500S depend on the phone system
configuration. Your phone system might not provide all of the features mentioned in
this document.
Configuration of the Cisco SPA 500S and assignment of the line buttons is
performed by the system administrator and is not described in this document. To
configure the Cisco SPA 500S:
• If the Cisco SPA 500S and attached IP phone are part of a Cisco SPA 9000
Voice System, we recommend that you use the Cisco SPA 9000 Setup
Wizard. For instructions on using the Setup Wizard, see the
System
Configuration Using the SPA 9000 Setup Wizard
document on Cisco.com.
See Appendix B, “Where to Go From Here” for the link to this document.
• If you want to manually configure the Cisco SPA 500S using the web user
interface for the IP phone to which the Cisco SPA 500S is attached, see the
Cisco SPA 500 Series and Wireless IP Phone Administration Guide on
Cisco.com. See Appendix B, “Where to Go From Here” for the link to this
document.
• If the Cisco SPA 500S and attached IP phone are used with a Broadsoft or
Asterisk server, see the Cisco SPA 500 Series and Wireless IP Phone
Administration Guide on Cisco.com. See Appendix B, “Where to Go From
Here” for the link to this document.
To Next Page
Loading...
Need help?
General
