DescriptionParameter
When set to Yes, the phone performs a blind transfer
when the speed dial function key is selected. When
set to no, the current connected call is held and a new
call to the speed dial destination is started.
For example, when a user parks a call using the speed
dial function, if the parameter is enabled, a blind
transfer is performed to the parking lot. If the
parameter is not enabled, an attended transfer is
performed to the parking lot.
Default: No
BXfer On Speed Dial Enable
When set to Yes, the phone performs a blind transfer
to a remote number. When set to no, blind transfer to
remote number is disabled.
BXfer To Remote Party Number Enable
Options to select a mode which displays on the phone
screen for BLF.
Default: Blank
BLF Label Display Mode
Unit
Enter the programming information for each line key for the Attendant Console unit.
DescriptionParameter
Indicates whether the key expansion module that is
added to the phone is enabled.
Unit Enable
Indicates whether the key expansion module that is
added to the phone is active.
Unit Online
Displays the hardware version of the key expansion
module that is added to the phone..
HW Version
Displays the software version of the key expansion
module that is added to the phone.
SW Version
TR-069
TR-069
DescriptionParameter
Settings that enables or disables the TR-069 function.
Default: Disabled
Enable TR-069
Cisco IP Phone 7800 Series Multiplatform Phones Administration Guide
302
Cisco IP Phone Troubleshooting
Unit
To Next Page
Loading...
Need help?
General
