Cisco 7965G Administration Guide

CHAPTER
5-1
Cisco Unified IP Phone 7965G and 7945G Administration Guide for Cisco Unified Communications Manager 6.0
OL-12650-01
5
Configuring Features, Templates, Services, and
Users
After you install Cisco Unified IP Phones in your network, configure their network settings, and add
them to Cisco
Unified Communications Manager, you must use the Cisco Unified Communications
Manager Administration application to configure telephony features, optionally modify phone
templates, set up services, and assign users.
This chapter provides an overview of these configuration and setup procedures. Cisco Unified
Communications Manager documentation provides detailed instructions for these procedures.
For suggestions about how to provide users with information about features, and what information to
provide, see
Appendix A, “Providing Information to Users Via a Website.”
For information about setting up phones in non-English environments, see Appendix C, “Supporting
International Users.”
This chapter includes following topics:
• Telephony Features Available for the Phone, page 5-2
• Configuring Corporate and Personal Directories, page 5-16
• Modifying Phone Button Templates, page 5-17
• Configuring Softkey Templates, page 5-18
• Setting Up Services, page 5-18
• Adding Users to Cisco Unified Communications Manager, page 5-19
• Managing the User Options Web Pages, page 5-19

Cisco 7965G Specifications

General

Protocol Support	SIP, SCCP
Weight	3.5 lbs (1.6 kg)
Ethernet	10/100 Mbps
Power	IEEE 802.3af Power over Ethernet (PoE)
Expansion Module Support	Supports up to two Cisco Unified IP Phone Expansion Modules
Speakerphone	Full-duplex speakerphone
Lines	6 lines
Codecs	G.711, G.729a, iLBC